Electronic Theatre Controls Emphasis Lighting Control System Specifikace stáhnout pdf (Strana 199)

15 Cue Playback 185

Manual Intensity Override

An intensity transition may be taken over manually and the transition captured by dropping the

fader down until it reaches the percentage of cue completion (i.e. if the cue is 50% complete, when

the fader is manually dropped to 50%, the intensity transitions will be captured and the intensity

portion of the cue completed by moving the fader manually between 50% and full or anywhere in

between). If the fader is dropped below 50%, the fader will fade all intensity values proportionally

from their captured values to their previous values.

If a fade is captured and the faders are not reset to 100% prior to the next press of the [Go] button,

the fader will automatically reset to 100% upon cue execution. Alternatively, you can set the fader

to 0% before executing the next cue to capture the cue for manual intensity control when the [Go]

button is pressed. Intensity control is released from the fader when the cue is considered complete

(when the fader is brought back to 100%).

This is true unless the cue has a “hold” attribute. You could provide a “hold” on a per cue basis to

allow the cue’s intensity (or whatever the fader potentiometer was manually controlling) to remain

under the control of the potentiometer even after it reaches full. The “hold” will remain until the next

cue is executed. When held, the potentiometers may be used to drop any values with manual

timing, even after the cue has reached full. The hold attribute is released when [Go] is pressed to

activate the next cue in the list.

If a pending cue has any manual control properties, you may either preset the fader to zero or, if it

is a virtual fader, the console will automatically set the fader to zero when the [Go] button is

pressed. The master fader pair must be manually set.

Manual intensity override is not possible if there is any manual timing in the cue, as the

potentiometer is already occupied with that control.

Manual Override

Manual override allows the potentiometer of the associated fader to control all parameters in a

transition state on that fader. When [Fader Controls] {Man Override} & [Load] are pressed, all

activity on that fader is frozen.

The potentiometer is used to manually complete the cue transition for all parameters. If the fader is

operating in a paired mode, the left fader controls the intensity upfade and all non-intensity

parameters, while the right fader controls all intensity downfade actions. Manual control override

automatically releases when the cue is complete.

A group of faders can be collected for manual override by pressing or clicking [Man Override] &

[Load] (continue adding faders by clicking the associated [Load] buttons).

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 337 338

Žádné komentáře

Electronic Theatre Controls Emphasis Lighting Control System Specifikace Strana 199