Electronic Theatre Controls Emphasis Lighting Control System Uživatelský manuál stáhnout pdf (Strana 113)

4 Live Editing 103

Note:

Dynamic effects are only recorded when the Dynamic Effect editing display is visible. If

you have returned to the Stage display while the dynamic effect is running and you record

a cue or submaster, the static “base” channel levels will be recorded to that target - not

the dynamic effect. Make sure to record your dynamic effects from the Dynamic Effect

editing display.

Editing the Device List

The order of devices in the Device List can be adjusted more specifically than the simple

[S7 - Sort Devices] command will allow. These methods are listed below.

• Enter fixtures or channels one at a time in the order in which you want them to cycle

through the dynamic effect. Use [And] and [Thru] to select multiple devices at a time.

• Use [Except] to remove specific channels from the fixture list.

• Use the mouse in the Emphasis mode console displays to select fixtures within the list.

Fixtures added when another fixture number is selected (displayed in yellow) will be

inserted above the selected fixture.

Adjustable Parameters in Dynamic Effects

Every dynamic effect will be created from a base Dynamic Effect Template. These

templates contain specific information to initially set up dynamic movement of a specific

type. You can alter the appearance of a dynamic effect by overriding these parameters and

recording the adjusted effect to a cue or submaster. You can make these parameter

adjustments in Stage as you create the effect (which allows you to immediately see how

your adjustments change the effect), or you can view the recorded dynamic effect in Blind

and adjust parameters there.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 317 318

Žádné komentáře

Electronic Theatre Controls Emphasis Lighting Control System Uživatelský manuál Strana 113