Electronic Theatre Controls Emphasis Lighting Control System Specifikace stáhnout pdf (Strana 331)

100

101

Express 125/250 User Manual, v.3.1 317

Installing MIDI

Connect the console to any MIDI equipment using a standard MIDI cable.

There are three round, 5-pin, DIN-type connectors labeled MIDI In, MIDI

Out, and MIDI Thru on the back of the console. Turn console power off,

then connect the cable from the MIDI Out of the electronic instrument or

sequencer to the MIDI In on the console. Connect the cable from the

MIDI In on the instrument or sequencer to the connector labeled MIDI

Out.

Follow these steps to connect MIDI equipment to the console:

1. Turn console power off.

2. Insert standard MIDI cable into the connector on the back of the

console labeled MIDI In. 3.If you are sending MIDI commands from

the console, insert another standard MIDI cable into the connector on

the back of the console labeled MIDI Out.

MIDI console connectors

DIN 5 pin female

MIDI pinout

1 not connected

2 Ground

3 not connected

4 MIDI +

5 MIDI –

Installing console lights

Plug the two Littlites into the connectors at the top rear of the console.

Bend the gooseneck of each to suit your needs.

CAUTION: Use of any other brand but Littlites is not recommended by

ETC. The results may be unexpected.

Connectors

XLR 3 pin female

Pinout for Littlites

1 Chassis ground

2 Dimming leg

3. + 12 Vdc

Connect the light between pins 2 and 3.

1 2 ... 326 327 328 329 330 331 332 333 334 335 336 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Electronic Theatre Controls Emphasis Lighting Control System Specifikace Strana 331

Komentáře k této Příručce