Electronic Theatre Controls Emphasis Lighting Control System Specifikace stáhnout pdf (Strana 90)

100

101

76 Chapter 6 Adding moving lights to the show

Working with fixtures

Following are some principles to keep in mind when setting fixture

attribute levels.

• If a fixture has a strobe attribute, that attribute must be set above zero

so that the light can be seen.

• The intensity attribute is selected by default unless you select an

attribute. Use this as a shortcut method to set fixture intensities. For

example, set the intensity of three moving lights on stage by pressing

[Stage] [S8], Fixture, [1] [thru] [3] [Full].

• If you wish, you can assign attribute levels without using the Fixture

Box. For instance, if a fixture is patched to channels 1 through 20, you

can set the levels of channels 7 and 8 as follows: press [Stage]

[Channel] [7] [And] [8] [At] [5] [Enter].

• If you are working with fixtures directly but don’t want the Fixture Box

on the screen, press [Clear] to remove it. The encoders remain active

when the Fixture Box is cleared. You can clear away the Fixture Box

even in the midst of a lengthy command sequence without altering

the results. For instance, set the intensity of fixtures 1 through 3 to

full and clear away the Fixture Box in one command sequence as

follows: press [Blind] [S8], Fixture, [1] [thru] [3] [Clear] [Full].

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 379 380

Komentáře k této Příručce

Žádné komentáře

Electronic Theatre Controls Emphasis Lighting Control System Specifikace Strana 90

Komentáře k této Příručce